MTD E6C3H Manual del operador descargar pdf (Pagina 6)

SECTION3: KNOWYOURSNOWTHROWER

Traction Control/ Lever-

Auger Control

Headlight

Discharge_ /

Chute

Shoe

ger Drive Control

Directional

Control

_-"=_ ;anio ut

Electric

_:__ _1_%_._/ Starter

Button

,_ / !/ J Switch

Box

_\\ _ ) })))7./ _Recoil

Starter

Thr,)ttle Handle

Control

Primer

Choke_

Figure 4

WARNING: Read, understand, and follow all

instructions and warnings on the machine

and in this manual before operating.

TractionControl/AugerControlLock

The traction control is located on the right handle.

Squeeze the traction control to engage the wheel drive.

Release to stop. See Figure 4.

This same lever also locks the auger control so you

can turn the chute directional control without

interrupting the snow throwing process. If the auger

control is engaged along with the traction control, the

operator can release the auger control (on the left

handle) and the augers will remain engaged. Release

the traction control to stop both the augers and track

drive (auger control must also be released).

IMPORTANT:Always release tractional control before

changing speeds.

AugerDriveControl

The auger drive control is located on the left handle.

Squeeze the control grip to engage the augers.

Release to stop the snow throwing action. (Traction

control must also be released.) See Figure 4.

Skid Shoe

The position of the skid shoe is determined by the

condition of the ground from where snow has to be

removed. See Figure 4.

ShiftLever

The shift lever is located in the center of the handle

panel and is used to determine both ground speed and

direction of travel. It can be moved into any of eight

positions. See Figure 4.

Forward

Your snow thrower has six forward (F) speeds. Position

number one (1) is the slowest. Position number six (6)

is the fastest.

Reverse

Your snow thrower has two reverse (R) speeds. R1 is

the slower, while R2 is the faster of the two.

IMPORTANT: Always release tractional control before

changing speeds.

ChuteDirectionalControl

The chute directional control is located on left side of

the snow thrower. See Figure 4.

To change the direction in which snow is thrown, turn

chute directional control as follows:

• Crank clockwise to discharge to the left.

• Crank counterclockwise to discharge to the right.

SafetyIgnitionKey

The safety ignition key must be fully inserted in the

switch before the unit will start. Remove the ignition key

when the snow thrower is not in use. See Figure 4.

IMPORTANT:Do NOT attempt to turn the key.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comentarios a estos manuales

Sin comentarios

MTD E6C3H Manual del operador Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve MTD E6C3H