MTD E6C3H Manual del operador descargar pdf (Pagina 5)

SECTION2: ASSEMBLINGYOURSNOWTHROWER

NOTE: References to right or left side of the snow

thrower are determined from behind the unit in the

operating position. The "operator's position" is defined

as standing directly behind the snow thrower, facing the

handle panel.

LooseParts

The augers are secured to the auger shaft with two

shear bolts and hex lock nuts. If you hit a foreign object

or ice jam, the snow thrower is designed so that the

bolts may shear. Two replacement shear bolts and nuts

are provided for your convenience. Store in a safe

31aceuntil needed. See Figure 1.

Shear Bolts Hex Lock Nuts

Figure 1

Assembly

,_ WARNING: Disconnect the spark plug wire

and ground it against the engine to prevent

unintended starting.

• Remove the lower two plastic wing knobs, cupped

washers and carriage bolt (eyebolt on the left side)

from the lower handle. See Figure 2.

Wing Knobs,

Washers

and Bolts

• Raise the upper handle assembly until it locks over

the lower handle. See Figure 2 and Figure 3.

• Observe the lower rear area of the snow thrower to

be sure both cables are aligned with roller guides.

• Secure the upper handle and lower handle with the

two plastic wing knobs, cupped washers and

carriage bolt (eyebolt on the left side) previously

removed. See Figure 3.

Hex

Nut

Connector

Ey,

Knobs

Figure 3

• Adjust the eyebolt on the chute directional control

so the rod does not come into contact with the

engine by moving the hex nut against the handle (if

necessary). Retighten the wing nut to secure the

directional control in this position.

• Slide the connector down over the end of the lower

shift rod. See Figure 3. Tap the connector until it

locks on the lower shift rod.

NOTE: If the connector is not properly assembled, the

shift rod will pivot and you will not be able to change

speeds or change directions.

NOTE:

• Unwrap the headlight wire, which is attached to the

headlight beneath the handle panel.

• Wind the headlight wire around the right handle

until excess slack is removed.

• Plug the wire from the headlight into the wire lead

coming from the right side of the engine, beneath

the fuel tank.

Figure 2

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comentarios a estos manuales

Sin comentarios

MTD E6C3H Manual del operador Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve MTD E6C3H