MTD E600E Manual del operador descargar pdf (Pagina 9)

• Thread the ferrule onto the shift rod until the ferrule

lines up with the upper hole in the shift lever

(beneath the handle panel). Insert the ferrule into

the upper hole in the shift lever from the left side

when adjustment is correct. Secure with flat washer

and hairpin clip.

Make certain to check for correct adjustment of the shift

rod as instructed in the Final Adjustment section before

operating the snow thrower.

Figure 9

Final Adjustments

Auger Control Adjustment

To check the adjustment of the auger control, push

forward on the left hand control, depressing the rubber

bumper on end of control. There should be slack in the

cable. Release the control. The cable should be

straight. Make certain you can depress the auger

control against the left handle completely.

If necessary, loosen the hex jam nut and thread the

cable in (for less slack) or out (for more slack) as

necessary. Recheck the adjustment. Tighten the jam

nut against the cable when correct adjustment is

reached. SeeFigure 10.

Figure 10

Traction Control And Shift Lever

Adjustment

To check the adjustment of the traction control and shift

lever, move the shift lever all the way forward to sixth

(6) position. With the traction control released, push the

snow thrower forward. The unit should move forward

freely. Then engage the traction control grip. The

wheels should stop turning.

Now release the traction control grip, and push the unit

again. Move the shift lever back to the fast reverse

position, then all the way forward again. There should

be no resistance in the shift lever, and the wheels

should keep turning.

If you have resistance when moving the shift lever or

the wheels stop when they should not, loosen the jam

nut on the traction control cable and unthread the cable

one turn. If the wheels do not stop when you engage the

traction control grip, loosen the jam nut on the traction

control cable and thread the cable in one turn. Recheck

the adjustment and repeat as necessary. Tighten the

jam nut to secure the cable when correct adjustment is

reached.

Adjusting The Skid Shoes

The space between the shave plate and the ground can

be adjusted. For close snow removal, place skid shoes

in the low position. Use middle or high position when

area to be cleared is uneven. See Figure 11.

Adjust skid shoes by loosening the four hex nuts and

carriage bolts and moving skid shoes to desired

position. Make certain the entire bottom surface of skid

shoe is against the ground to avoid uneven wear on the

skid shoes. Retighten nuts and bolts securely.

Washer

Flat

Hairpin

Clip

Ferrule

Shift Arm

Assembly

Shift Rod

Washer

Flat

Hairpin

Clip

Hex Lock

Nut

Make Sure

Cable is Straight

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios

MTD E600E Manual del operador Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve MTD E600E