MTD E600E Manual del operador descargar pdf (Pagina 16)

600/610E has only one auger belt).

• Remove the plastic belt cover on the front of the

engine by removing the two self-tapping screws.

See Figure 22.

Figure 22

• Drain the gasoline from the snow thrower, or place

a piece of plastic under the gas cap.

• Tip the snow thrower up and forward so that it rests

on the housing.

• Remove six self-tapping screws from the frame

cover underneath the snow thrower.

• Roll the front and rear auger belts off the engine

pulley. See Figure 23.

Figure 23

• Unhook the idler spring from the hex bolt on the

auger housing. See Figure 24.

• Back out the stop bolt to allow the belts to slip

between the bolt and auger pulley. See Figure 25.

NOTE: It may be necessary to loosen the six hex nuts

that fasten the frame to the auger housing to aid in belt

removal.

Figure 24

• Lift the rear auger belt from the auger pulley, and

slip belt between the support bracket and the auger

pulley. See Figure 24. Repeat this step for front

auger belt (except models 600/610E).

• Replace both auger drive belts by following

instructions in reverse order.

Drive Belt

• Follow steps 1 through 4 of previous instructions.

• Pull idler pulley up, and lift belt off engine pulley

and friction wheel disc. See Figure 23.

• Back out the stop bolt until the support bracket

rests on the auger pulley. See Figure 25.

• Slip belt between friction wheel and friction wheel

disc. Remove and replace belt. Reassemble

following the instructions in reverse order.

NOTE: The support bracket must rest on the stop bolt

after the new belt has been assembled. See Figure 25.

Self-Tapping

Screws

Belt

Cover

Rear Auger

Drive

Belt

Engine

Pulley

Front Auger

Idler

Pulley

Idler

Pulley

Engine

Pulley

Belt

Friction

Wheel

Support

Bracket

Auger

Pulley

Idler

Spring

Auger

Housing

Support

Bracket

Spring

Frame

Rear Auger

Belt

Front Auger

Pulley

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comentarios a estos manuales

Sin comentarios

MTD E600E Manual del operador Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve MTD E600E