MTD 27-Ton Manual de servicio descargar pdf (Pagina 25)

Hydrualic Diagnosis

F. Slowly close the needle valve to build 2,000 PSI (220

Bars).

See Figure 3.19.

G. Record the engine RPMs on the worksheet.

H. Record the flow meter reading on the worksheet.

I. Record the pressure reading on the worksheet.

J. IMMEDIATELY open the needle valve, then turn-off

the engine.

K. Record the rated flow rate from the pressure mode flow capacities chart on to the worksheet.

Interpreting the test results:

NOTE: The engine governor should hold engine RPMs constant during the test.

• If the pump fails to produce the base-line flow rate, but engine RPM is 3,500, there is problem with the

drive system (engine coupler) or the pump.

• The flow should be within 1 GPM (3.8 LPM) of the rated capacity.

• If flow droops more than 1 GPM (3.8 LPM), and the engine RPM falls, there is an engine problem

• If pressure fails to build, there is a problem with the drive system (engine coupler, keys or the pump).

• If flow drops more than 1 GPM (3.8 LPM), the engine RPM does not change, and the engine exhaust note

does not change, there is a problem with the drive system (engine coupler and spider) or the pump.

• If base-line flow is within 1 GPM (3.8 LPM), pressure builds to 2,000 PSI (138 Bars) when the needle

valve is closed; the pump, engine, and drive are working properly.

• To identify drive problems examine the engine coupler and spider.

• If the pump fails to switch from volume mode to pressure mode within 100 PSI of the rate by-pass setting,

the pump is bad.

Figure 3.19

2,000 PSI

1.5 lpm

Do NOT exceed 3,200 PSI (220

Bars). This test is performed up-

stream of the relief valve in the log

splitter hydraulic system, rendering the relief

valve ineffective during the test. Over-load-

ing the system will damage the pump.

Pump By-pass Settings

Pump Tonnage

By-pass

P r e s s u r e

100 PSI

718-04127 21,25 and

500 (34 bar)

718-04729 27 ton HP

pump

1,000 (69

bar)

718-04128 33 700 (48 bar)

Pressure Mode Flow Capacities

Pump Tonnage GPM/LPM

0.5 gpm

718-04127 21,25 and

1.5 (5.5 lpm)

718-04729 27 ton HP

pump

3 (11 lpm)

718-04128 33 3 (11 lpm)

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

Comentarios a estos manuales

Sin comentarios

MTD 27-Ton Manual de servicio Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Cortadoras De Troncos MTD 27-Ton