Mtd 241-521-000 Manual de usuario descargar pdf (Pagina 9)

NOTE: In order to idle smoothly, a new engine may re

quire 3 to 5 minutes running above slow idle speed. Idle

speed has been adjusted to be correct after this break-

in penod.

7. If weather is cold, run wedge up and down beam

6 to 8 times to circulate the hydraulic fluid, which

will warm and thin the fluid.

TO STOP ENGINE

1. Move throttle control lever to OFF position.

2. Disconnect spark plug wire from spark plug to pre-

. vent accidental starting while equipment is unat

tended.

USING THE LOG SPLIHER

Use the log splitter only on a level, hard surface.

Never stand next to the splitting wedge when

operating the log splitter. Always stand behind the

reservoir tank. See figures 13 and 14. Never attempt

to cut a log in half sideways. Always split the log

lengthwise. Maximum length of log to be split is 24".

WARNING: Always use the log splitter in

the vertical position only when splitting

heavy logs.

The control handle has three positions:

FORWARD—Push the control handle down for vertical

operation, push it forward for horizontal operation-

splitting wedge moves toward the end plate. Con

trol handle will return to neutral position as soon as

handle is released.

NEUTRAL (Middle position)—Splitting wedge stops

in place.

REVERSE—Push the control handle upward for ver-

ical operation, push it toward the rear for horizontal

operation—Splitting wedge returns. The control han

dle will lock in the reverse position, and will return

to neutral automatically when the reverse stroke is

complete.

Splitting

Wedge

\ ^Reservoir

Tank

End Plate

FIGURE 13.—Vertical Position

Splitting

Wedge

Control

Handle

End

FIGURE 14.—Horizontal Position

TO OPERATE LOG SPLIHER:

1. Set throttle at maximum speed.

2. Place the log upright, on top of end plate for ver

tical opération, and on top of beam for horizontal

operation.

3. Push the control handle in forward position until

the splitting wedge just contacts the log. Release

the control handle.

4. Step behind the reservoir tank (see figures 13

or 14) and push the control handle in forward posi

tion until the log is split.

5. Move the control handle to reverse position to

return the splitting wedge.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comentarios a estos manuales

Sin comentarios

Mtd 241-521-000 Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Mtd 241-521-000