Mtd CSV 070 Manual de usuario

Service ManualMTD Products LLC - Product Training and Education DepartmentFORM NUMBER 769-014225/2004SELF PROPELLED CHIPPER VAC - CSV 070 NOTE: These

Self-propelled Chipper Shredder Vacuum63.7. Safely support rear of the unit so that the rear wheels are off the ground, and remove rear hub caps. See

Self-propelled Chipper Shredder Vacuum 73.13. Remove three self tapping screws holding trans-mission brace to the frame using an 3/8 socket. 3.14. Rem

Self-propelled Chipper Shredder Vacuum83.19. Pivot transmission rearward while sliding it to the right. See Figure 3.19.3.20. Once the left side comes

Self-propelled Chipper Shredder Vacuum 94.7. Use a 1/4” wrench to remove the three Screws securing the black plastic nozzle to the lower housing. They

Self-propelled Chipper Shredder Vacuum104.11. Block the impeller with a chock, to keep it from rotating. Using a 9/16” socket, remove the bolt, lock w

Self-propelled Chipper Shredder Vacuum 115. CHIPPER BLADE REMOVAL5.1. Disconnect H.T. lead from the spark plug.5.2. Remove the three bolts holding the

0 TABLE OF CONTENTSSafety Switch ...

Self-propelled Chipper Shredder Vacuum 1ABOUT THIS SECTION:In model year 2000, MTD introduced a vertical crank-shaft lawn vacuum with a 22” clearing w

Self-propelled Chipper Shredder Vacuum21.4. If slight pressure on the tab breaks continuity, adjusting the tab by bending it downward will enable the

Self-propelled Chipper Shredder Vacuum 31.11. The switch should not show continuity when the plunger is pressed. See Figure 1.11.NOTE: “OL” meter read

Self-propelled Chipper Shredder Vacuum42.4. Watch the travel of the variable speed sheave (pulley) on the input shaft. It may be necessary to remove t

Self-propelled Chipper Shredder Vacuum 52.11. Confirm that the drive gears are installed on the correct side. See Figure 2.11.NOTE: There is an “R” on