MTD K-Style Manual del operador descargar pdf (Pagina 7)

Assembly& Set-Up

Contentsof Carton

One Snow Thrower

One Snow Thrower Operator's

Manual

Two Replacement Auger Shear Pins

Hex Rod

One Product Registration Card

Chute Assembly

Assembly

Remove all loose parts before assembling.

Handle Assembly

1. Place the shift lever in the Forward-6 position

2. Observe the lower rear area of the snow thrower to be sure

both cables are aligned with roller guides before pivoting

the handle upward. Pivot the handle upward. See Fig. 3-1.

Figure 3-1

NOTE: Make certain the upper ends of each cable are

seated properly in its bracket.

Secure the handle by tightening the plastic knob located

on both the left and right sides of the handle. Remove

and discard any rubber bands, if present. They are for

packaging purposes only.

ChuteAssembly

1. Remove cotter pin, wing nut and hex screw from chute

control head and clevis pin and bow-tie cotter pin from

chute support bracket. See Fig. 3-2.

Bracket

Figure 3-2

2. Insert hex rod into chute control head. Push rod as far into

chute control head as possible, keeping the holes in the

hex rod pointing upward. See Fig. 3-3.

Figure 3=3

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Sin comentarios

MTD K-Style Manual del operador Pagina 7