MTD K-Style Manual del operador descargar pdf (Pagina 25)

7. Drive BeltRemove the belt from around the auger pulley, and slip the

belt between the support bracket and the auger pulley.

See Fig. 8-5.

Figure 8-5

Replace the auger belt by following instructions in reverse

order.

NOTE: Do not forget to reinstall the shoulder screw

and reconnect the spring to the frame after installing a

replacement auger belt.

After replacing the auger belt, perform the Auger Control

test on page 11 of the Assembly and Set-Up section.

To remove and replace your snow thrower's drive belt, proceed

as follows:

1. To prevent spillage, remove all fuel from tank by running

engine until it stops. Do not attempt to pour fuel from the

engine.

2. Remove the plastic belt cover on the front of the engine by

removing the two self-tapping screws. Refer to Fig. 8-1.

3. Remove the belt as follows. See Fig. 8-6.:

Figure 8-6

a. Roll the auger belt off the engine pulley.

b. Use a wrench to pivot the idler pulley toward the

right.

c. Lift the drive belt off engine pulley.

Carefully pivot the snow thrower up and forward so that it

rests on the auger housing.

Remove the frame cover from the underside of the snow

thrower by removing the self-tapping screws which secure

it. Refer to Fig. 8-3.

SECTION 8 -- SERVICE 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Sin comentarios

MTD K-Style Manual del operador Pagina 25