MTD 31AE6FHG705 Manual del operador descargar pdf (Pagina 9)

AugerControl

s AUGER

CONTROL

The auger control is located on the left handle.

Squeeze the control grip against the handle to engage

the augers and start snow throwing action. Release to

stop.

DriveControl

DRIVE

CONTROL

The drive control is located on the right handle.

Squeeze the control grip against the handle to engage

the wheel drive. Release to stop.

ChuteDirectionalControl

CHUTE DiRECTiONAL CONTROL

DISCHARGE

LEFT

The chute directional control is located on left side of

the snow thrower.

To change the direction in which snow is thrown, turn

chute directional control as follows:

• Crank clockwise to discharge to the left.

• Crank counterclockwise to discharge to the right.

To change the distance of snow discharge from the

chute, refer to the Making Adjustments section on

page 13.

Two-WayChuteControl(ifEquipped)

f _

CHUTE DiRECTiONAL CONTROL

BISCHARGE_JBISCHARGE

J =

CHUTETiLT

The two-way chute control is meant to control the

distance of snow discharge from the chute.

• To change the angle/distance which snow is

thrown, pivot the joy-stick forward or backward.

IgnitionKey

The ignition key must be inserted and snapped in place

in order for the engine to start. Remove the ignition key

to prevent unauthorized use of equipment.

IMPORTANT:Do not turn the ignition key in an attempt

to start the engine. Doing so may cause it to break.

Clean-OutTool

WARNING: Never use your hands to clear

a clogged chute. Shut off engine and remain

behind handles until all moving parts have

stopped before unclogging. Use the clean-

out tool or a stick to unclog.

The clean-out tool is fastened to the top of the auger

housing with a mounting clip. The tool is designed to

clear a clogged chute. Refer to OperatingYourSnow

Thrower section for more detailed information regarding

the clean-out tool.

NOTE: This item is fastened with a cable tie to the

rear of the auger housing at the factory. Cut the cable

tie before operating the snow thrower.

HeatedHandlesSwitch(ifEquipped)

This switch is located on the right side of the snow

thrower dash panel. To activate the heated handles,

toggle the switch to the right to generate heat within the

handle grips. Toggle the switch to the left to the OFF

position after using the snow thrower.

SkidShoes(stylevariesbymodel)

Position the skid shoes based on surface conditions.

Adjust upward for hard-packed snow. Adjust downward

when operating on gravel or crushed rock surfaces.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios

MTD 31AE6FHG705 Manual del operador Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve MTD 31AE6FHG705