MTD 31AE6FHG705 Manual del operador descargar pdf (Pagina 17)

DriveBeltReplacement

To remove and replace your snow thrower's auger belt,

proceed as follows:

1. Remove the plastic belt cover on the front of the

engine by removing the two self-tapping screws.

• Drain the gasoline from the snow thrower, or place

a piece of plastic under the gas cap.

• Carefully pivot the snow thrower up and forward so

that it rests on the auger housing.

2. Remove the frame cover from the underside of the

snow thrower by removing four self-tapping screws

which secure it.

3. a. Grasp the idler pulley and pivot it toward the

right.

b. Insert a screw driverthrough aligning holes in

both the idler bracket and the engine.

c. Roll the auger belt off the engine pulley.

d. Lift the drive belt off engine pulley.

4. Slip the drive belt off the pulley and between friction

wheel and friction wheel disc.

• Remove and replace belt in the reverse order.

/!oi

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Sin comentarios

MTD 31AE6FHG705 Manual del operador Pagina 17