MTD 21AA413H700 Manual del operador descargar pdf (Pagina 6)

Retainer Bracket

Shoulder Bolt & Lock Nut

Figure 3

• Place the hex opening of the flange nut retainer

bracket over the flange nut securing the handle

adjustment crank and install the lock nut on the

lower shoulder bolt. See Figure 4.

• Pivot handle assembly into position desired.

Tighten the bottom bolt, lock nut, and the handle

adjustment lock securely.

Handle Ad ustment Crank

Retainer Bracket

Gear

Gear Shift Rod

Handle

ustment Rod

(Model Series 420)

Rubber Washer

Hairpin Clip

Figure 4

AttachingGearShiftRod

• Remove the T-handle, hairpin clip, flat washer and

rubber washer from the end of the gear shift rod.

Slide the rod up through the right side of bracket on

the front of the handle assembly. See Figure 5.

• Insert the end of the gear shift rod through the

opening inthe top of the shift cover and into the

shift bracket. Secure with rubber washer first, flat

washer, and then hairpin clip. See Figure 5.

• Install the nut and T-handle on the gear shift rod.

Figure 5

AttachingClutchCable

• Route the clutch cable underneath the handle and

through the cable clip. Be careful not to bend or

kink the cable. See Figure 6.

Handle Adjustment Crank

Cable

Clip

Figure 6

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Sin comentarios

MTD 21AA413H700 Manual del operador Pagina 6