MTD 31A-2M1A731 Manual del operador descargar pdf (Pagina 8)

Filling Oil Sump

1.

Remove the oil fill cap dipstick from oil filler tube by 2.

rotating counter-clockwise and lifting the dipstick out of

the engine. Wipe the dipstick clean with a shop rag.

Insert oil fill cap dipstick back into oil filler tube. On 3.

threaded oil cap/dipstick units, do not screw the cap on to

check, just rest cap on threads to gain proper reading. On

quarter-turn cap units, tighten down the cap to check the

oil level. Refer to the proceeding instructions based on the

engine model that you have for more detailed information

regarding checking the oil level.

Remove the oil fill cap/dipstick from the oil filler tube. Note 4.

the oil level and if the oil reading on the dipstick is below



Insert oil fill cap/dipstick back into oil filler tube. Tighten by 5.

rotating the cap clockwise until firmly seated.

Wipe away any spilled oil.6.

NOTE: To change the oil, see Checking and Changing Oil

instructions in the Maintenance Section of this manual.

Fuel Recommendations

Operating the engine with E85 fuel, an

oil/gasoline mixture, dirty gasoline, or gasoline over

30 days old that hasn’t been fuel stabilizing additive

may result in damage to your engine’s carburetor.

Subsequent damage would not be covered under

the manufacturer’s warranty.

Use automotive gasoline (unleaded or low leaded to minimize

combustion chamber deposits) with a minimum of 87 octane.





dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank.



Gasoline is extremely flammable and is

explosive under certain conditions.

Refuel in a well-ventilated area with the engine stopped. 

Do not smoke or allow flames or sparks in the area where

the engine is refueled or where gasoline is stored.

Do not overfill the fuel tank. After refueling, make sure the 

tank cap is closed properly and securely.



fuel vapor may ignite. If any fuel is spilled, make sure the

area is dry before starting the engine.

Avoid repeated or prolonged contact with skin or 

breathing of vapor.

Adding Fuel

WARNING! An adult should fuel this engine. NEVER

allow children to refuel this engine. Gasoline (fuel)

vapors are highly flammable and can explode. Fuel

vapors can spread and be ignited by a spark or flame

many feet away from engine. To prevent injury or

death from fuel fires, follow these instructions:

DO NOT use leaded fuel.

Fuel must be fresh and clean. NEVER use fuel left over 

from last season or stored for long periods.

NEVER mix oil with fuel.

DO NOT use fuel containing Methanol (Wood 

Alcohol)

1.

2.

Clean area around the fuel fill cap and remove the fuel fill 3.

cap.

Using an approved red GASOLINE container, add fuel 4.

slowly, being careful to avoid spilling.

NOTE: On tanks with a fuel level indicator, fill the tank

until the fuel reaches the “fuel full” indicator mark. See Fig.

3-5. All other tanks, fill tank until the fuel reaches a ⁄ inch

below the bottom of the filler neck to allow space for fuel



Replace the fuel cap and tighten securely. 5.

Wipe up spilled fuel before starting

engine. If fuel is spilled DO NOT start engine. Move

machine away from area of spillage. Avoid creating

any source of ignition until fuel vapors are gone.

Fuel Level Indicator

Top View



 se c t i O n 3— se t -up

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comentarios a estos manuales

Sin comentarios

MTD 31A-2M1A731 Manual del operador Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas De Jardín MTD 31A-2M1A731