Mtd 24604C Manual de usuario descargar pdf (Pagina 8)

BLADE PLANE ADJUSTMENT

The cutting blade can be adjusted to eight positions

from vertical to horizontal. To adjust, release the

adjustment lever on the pivot bracket and rotate the

spindle housing. Place adjustment lever in nctch

desired. See figure 13.

When the blade is adjusted toward the horizontal

position, the front wheels must also be adjus ed.

Remove the two hairpin cotters and slide the specer

and wheel to the right as shown in figure 14. Rein sert

the hairpin cotters.

NOTE

If the wheels are not adjusted, the

blade will hit the left front wheel,

causing the belt to slip.

ADJUSTMENT

LEVER

FIGURE 13

HAIR PIN COTTERS

SPACER

Become familiar with all the controls and adjustments

before operating the edger so you can adjust it easily

to a variety of cutting and trimming conditions. While

the engine is running, DO NOT ATTEMPT TO MAKE

ANY ADJUSTMENTS except with the throttle

control.

OPERATION

Fill the crankcase with oil using a high quality

detergent oil classified " For Service MS." Nothing

should be added to the recommended oil. SUM

MER - Use SAE 30. WINTER - (Below 40“ F.) Use

SAE 5W-20 or SAE 10W.

Place the engine level. Remove filler plug. FILL

THE OIL SUMP TO POINT OF OVERFLOW.

Pour slowly. See figure 15.

Fill the fuel tank with clean, fresh, lead-free, low-

lead, or regular grade leaded gasoline. DO NOT

MIXOILWITH GASOLINE.

FIGURE 14

3. Move the engagement handle (depth control) back

as far as it will go and place in the last notch. See

figure 12.

4. Set the throttle control in "START" position.

5. Pull the choke knob out.

NOTE

A warm engine may not require

choking.

6. Grasp the starter handle and pull out the cord

rapidly. Return it slowly to the engine. If the

engine does not start after two pulls, move the

throttle control to the "FAST" position.

7. After engine starts, push choke knob in gradually.

To stop engine, move throttle control to "STOP"

position. Disconnect spark plug wire and ground to

prevent accidental starting while equipment is un

attended.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Mtd 24604C Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Mtd 24604C