MTD K-Style Manual del operador descargar pdf (Pagina 8)

3 Set-Up

Finish securing chute control assembly to chute support

bracket with wing nut and hex screw removed earlier.

See Fig. 3-4.

Figure 3-4

4. Check that all cables are properly routed through the cable

guide on top of the engine. See Fig. 3-5.

Figure 3-5

ShearPins

A pair of replacement auger shear pins and bow tie cotter pins

are included with your snow thrower. Store them in your snow

thrower's dash panel until needed. See Fig. 3-6.

Figure 3-6

ChuteClean-0ut Tool

The chute clean-out tool is fastened to the top of the auger

housing with a mounting clip and a cable tie at the factory. Cut

the cable tie before operating the snow thrower. See Fig. 3-7.

Chute Clean=out Too

Figure 3-7

8 I SECTION3-- ASSEMBLY& SET-UP

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Sin comentarios

MTD K-Style Manual del operador Pagina 8