MTD 737-0168 Manual del operador descargar pdf (Pagina 6)

AttachingtheChuteAssembly

NOTE: Your chute assembly may or may not be

assembled. If # requires assembly use the following

instructions.

j Chute Assembly

Hex Screw

j._ J-f

Hex Lock Nut

Chute Flange

Keeper

Figure 3

• Place chute assembly over chute opening, with the

opening in the chute assembly facing the front of

the unit. Place chute flange keepers beneath lip of

chute assembly, with the flat side of chute flange

keeper facing downward.

• Insert hex cap screws up through chute flange

keeper and chute assembly as shown in Figure 3.

Secure with hex flange Iocknuts. Tighten with two

7/16" wrenches. Do not over tighten.

AttachingChuteCrank

• Remove the hairpin clip from the upper chute crank

and slide the upper chute crank through the upper

chute crank bracket and into the lower chute crank.

A pair of pliers may help in this job.

Upper Chute Crank

r er Chute

_ Crank Bracket

_''Hairpin Clip

_Lower Chute Crank

Figure 4

Align the two holes on both chute cranks and

secure with the hairpin clip removed earlier. See

Figure 4.

With the hex nuts loosened on the lower chute

crank bracket (see Figure 5) adjust the bracket so

that the spiral on the chute crank fully engages the

teeth on the chute assembly. Tighten the nuts on

the lower chute crank bracket securely.

\ Chute Directional

_C ontrol

__2

Chute / _ "-_ _/'-----_

Lower Chute__

Bracklet-_ r _ _/ --_

Lock Nuts

Figure 5

• The cable ties normally are loosely installed on

each side of the lower handle at the factory. Pull the

cable ties tight to secure. Trim excess from the

ends of cable ties.

• If not already attached, slip the cables that run from

the handle panel to the discharge chute into the

cable guide located on top of the engine.

See Figure 6.

Cables Cable

Guide

Figure 6

Wrap the wire from the head lamp down the right

handle until the wire can be plugged into the

alternator lead wire under the fuel tank.

Alternator Lead

NOTE: Wheels are omitted from illustration for clarity.

Figure 7

1 2 3 4 5 6 7 8 9 10 11 ... 30 31

Comentarios a estos manuales

Sin comentarios

MTD 737-0168 Manual del operador Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve MTD 737-0168