MTD 31AE5MLG729 Manual del operador descargar pdf (Pagina 6)

Setting Up

Your Snow

Thrower

IMPORTANT: Two replacement auger shear pins are

included with this manual (or stowed in the plastic handle

panel). Refer to Augers on page 16 for more information

regarding shear pin replacement.

1. Observe the lower area of the snow thrower to be

sure both cables are aligned with roller guides before

pivoting handle upward.

a. Pull up and back on upper handle as shown in

Figure 1. Align upper handle with the lower handle.

b. Tighten hand knobs securing upper handle to

lower handle.

2. If it’s not already attached from the factory, position

the chute assembly (forward-facing) over the chute

base. See Figure 2.

3. a. Insert the round end of the chute control assembly

on the short tube of the chute assembly as shown

in Figure 3.

b. Secure other end of the chute control assembly

onto the chute support bracket.

4. Secure the round end of the chute control assembly

to the chute assembly with wing nut provided. See

Figure 4.

5. Check that all cables are properly routed through the

cable guide on top of the engine. See Figure 5.

The extension cord is fastened with a cable tie to the rear

of the auger housing for shipping purposes. Cut the cable

tie and remove it before operating the snow thrower.

CAUTION: Prior to operating your snow thrower, refer

to Auger Control Test on page 11. Read and follow all

instructions carefully, and perform all adjustments

to verify your snow thrower is operating safely and

properly.

Figure 3

Figure 2

NOTE: All references

in this manual to the

left or right side of the

snow thrower is from

the operating position

only. Exceptions, if any,

will be specified.

Figure 1

Figure 4

IMPORTANT

This unit is shipped

with the engine full of

oil. After assembly,

refer to the Tecumseh

Engines manual

packed separately with

your snow thrower

for fuel and oil fill-up

details.

NOTE: This Operator’s

Manual covers several

models. Snow thrower

features vary by

model. Not all features

discussed and/or

illustrated in this

manual are applicable

to all snow thrower

models.

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comentarios a estos manuales

Sin comentarios

MTD 31AE5MLG729 Manual del operador Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve MTD 31AE5MLG729