MTD 683 Manual del operador descargar pdf (Pagina 8)

Assembly & Installation

Installing the Bagger Assembly

To Install the bagger mounting bracket, follow these steps:

1. Remove, and discard, the four self-tap bolts on the rear

frame of the tractor, as shown in Figure 4-1.

Figure 4-1

2. Install the bagger mounting bracket on the tractor, using

four 710-3296 hex bolts from hardware pack 683-05063.

Feed each hex bolt through the tractor frame, the rear

hood mounting tube, and thread into the weld-nut on the

bagger mounting bracket, as shown in Figure 4-2.

Figure 4-2

3. Install the grass-bag mounting assembly onto the bagger

mounting bracket by lowering it down (1) and fitting the

assembly into the slot provided in the mounting bracket.

See the Inset in Figure 4-3.

4. Secure the grass-bag mounting assembly to the bagger

mounting bracket using the attachment knob (720-04061)

found in the hardware pack (683-05063). See (2) in Figure 4-3.

Figure 4-3

5. Remove the protective caps on the bagger cover hood

mounting threads and attach the bagger hood over the

grass-bag mounting assembly as shown in Figure 4-4. Align

the tabs on the hood into the slots on the grass-bag mounting

assembly. Secure the bagger hood using two flange lock nuts

(712-04150) included in the same hardware pack.

Figure 4-4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

MTD 683 Manual del operador Pagina 8