MTD 570 Series Manual de usuario descargar pdf (Pagina 10)

1. Operating instructions

1.1 Unit description

The hydraulically controlled pressurized Small-Instantaneous Water Heater is designed to heat water for one

draw off point. When the draw-off ﬁtting is opened, the heating capacity switches on automatically and the

water is heated. The hot water output is dependent on the cold water temperature, the heating capacity, and

the ﬂow rate.

1.2 The most important points in brief

Temperature adjustment is effected using the ﬁtting:

– To increase the temperature, restrict the ﬂow rate a little.

– For low temperatures, increase the ﬂow rate or mix in cold water.

1.3 Hot water output

Typ Leistung bei 230 V Warmwasserleistung*

MTD 350 3,5 kW 2,0 l/min

MTD 440 4,4 kW 2,5 l/min

MTD 570 5,7 kW 3,3 l/min

* The built-in automatic ﬂow regulation provides a constant ﬂow rate. Temperature increase of about 25 K.

1.4 Safety instruction

In the case of temperature selection, water temperatures of over 60 °C can be reached at the hot water

outlet.

If it is intended that children or people with restricted physical, sensory or mental capabilities are to ope-

rate the appliance, they must only be permitted to do so after appropriate instruction has been provided

by the person responsible for their safety.

Children should be supervised to ensure that they do not play with the device.

Risk of scalding!

1.5 Important notes

If the water feed of the MTD has been interrupted - e.g. because of the danger of frost or work on the

water pipe, the following steps must be taken before the unit is brought back into operation:

1. Remove or switch off fuses.

2. Open a tap downstream of the unit until the unit and the cold water feed pipe are free of air.

3. Replace or switch on fuses again.

1.6 Maintenance and care

Maintenance work, such as for example checking the electrical safety, may only be carried out by a qualiﬁed

installer.

A damp cloth is sufﬁcient for care of the unit. Do not use any abrasive or corrosive cleaning agents.

Please de-scale or replace the enclosed jet regulator „SR“ regularly:

MTD 350 / MTD 440: SR 3 Best.-Nr. 14 35 02

MTD 570: SR 5 Best.-Nr. 27 05 82

1.7 First actions to be taken in the event of malfunction

.. . First actions to be taken in the event of malfunction „Please look up: „3. Fault ﬁnding by the user“

page 14.

In the event of maintenance and possibly repair work please inform the qualiﬁed installer of the data on the

identiﬁcation plate (

12):

MTD . . .

Model:

. . . . . .

E-Nr:

F-Nr:

. . . . . . . .

1.8 Operating and installation instructions

Keep these instructions carefully and pass them on to your successor in the event of a change in ownership,

in the event of maintenance and possible repair work they should be passed to the qualiﬁed installer for his

attention.

for the user and the qualiﬁed installer

272867-34655-0751 MTD 350 - 570.10 10 30.01.2008 16:19:49

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comentarios a estos manuales

Sin comentarios

MTD 570 Series Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Cortadoras De Troncos MTD 570 Series