MTD TP720r Manual del operador descargar pdf (Pagina 8)

On some units, the J-handle may be pre-installed. In this

case you must loosen screws and adjust the handle to fit

the operator. Go to step 5 if the J-handle is pre-installed.

INSTALLING AND ADJUSTING THE J-HANDLE

Place the J-handle between the top and middle

clamp pieces (Fig. 1).

(4) J-Handle

Top Clamp

Middle Clamp

Bottom Clamp e

Nuts _

Fig. 1

2. While holding the three pieces together, install the four

(4) screws through the top clamp and into middle clamp.

NOTE: The holes in the top and middle clamp will line up

only when assembled correctly.

Place the clamps and J-handle the over the shaft

housing and onto the bottom clamp.

4. Hold each hex nut in the bottom clamp recess with a

finger. Start screws with a large Phillips screwdriver.

Do not tighten until you make the handle adjustment.

5. Slide the J-handle in or out until the arrow/white line on

the decal touches the clamp assembly (Fig. 2). You must

first loosen the screws if the handle is pre-installed.

Fig. 2

6: While holding the unit in the operating position (Fig. 3),

position the J-handle to the location that provides you

the best grip.

INSTALLING THE CUTTING ATTACHMENT SHIELD

Use the following instructions if the cutting attachment

shield on your unit is not installed or if you ever need to

re-install it.

WARNING:Never operate the trimmer !

without the cutting attachment shield in

place to prevent serious personal injury. J

Slide the cutting attachment shield into the shield

mount on the cutting attachment. Align the screw

holes in the shield with the holes in the cutting

attachment (Fig. 4).

Shaft Housing

Cutting Attachment

Shield

Shield Mount

Cutting Attachment

Fig. 4

Place a hex lock nut into one of the three recessed

holes on the top of the cutting attachment shield (Fig 5).

Cutting Attachment

Shield

Fig. 5

3. Install a screw into the hole from the bottom of the

cutting attachment shield and screw it into the nut

installed in step 2 (Fig 6). Do not tighten.

4. Repeat steps 2 and 3 until all three screws have

been started, then tighten securely.

Fig, 3

7. Tighten the clamp screws evenly, until the J,handle

IS secure. Fig. 6

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Comentarios a estos manuales

Sin comentarios

MTD TP720r Manual del operador Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Cortadoras De Césped MTD TP720r