Mtd 241-622-000 Manual de usuario

$1.00•NOWNEirS GUIDEASSEMBLY • OPERATION • MAINTENANCE • PARTSVERTICAL LOG SPLITTERSModel Numbers 241-622-000 (5 H.P. 20 Ton) 241-623-000 (5 H.P. 22 T

USING THE LOG SPLITTER Use the log splitter only on a level, hard si rface. Never stand next to the splitting wedge when operating the iog spii

3. Attach the hitch to a towing vehicle, making certain to latch securely. Attach the safety chains to the towing vehicle.CARBURETOR

NOTEDrain the fluid and flush the reservoir tank and hoses with kerosene whenever any repair work is performed on the tank, hydrauli

NNOTEMake certain proper clearance is obtained before tightening set screw.PUMPTIRE PRESSURECheck sidewall of tire for manufacturer’s reco

Trouble Shooting GuideTrouble Possible Cause(siCorrective ActionEngine fails to start 1. Fuel tank empt/, or stale fuel.2. Blocked fuel lir^e.3. Sp

HOW YOUR LOG SPLITTER OPERATESCylinderRodCylinderDirectionalValveRelief ValveBreatherCap UnloadinqPilotPressureLinePumpReservoirHigh Voiume Low Pressu

HYDRAULIC TROUBLE SHOOTING GUIDEProblem Probable Cat se(s)Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft couplinc I C Ge

NOTES

Models 622 and 623NOTE: The engine is not under warranty by the log splitter manufacturer...If repairs or service is needed on the engine, please cont

Models 622 and 623PARTS LIST FOR MODELS 622 AND 623 LOG SPLITTERS1EF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1712-0359Slotted Nut 3/4-16

FOR LOG SPLITTER USERSNEVER:Use fluid below 0° F., or above 150° F.Use a solid engine/pump coupling Force pump when mounting Operate through relief va

ONE YEAR LIMITED WARRANTYFor one year from the date of original retail pure base, MTD PRODUCTS INC will either repair or replace, at its option, free

IMPORTANTRULES FOR SAFE OPERATIONA.THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSO

4.5.6.7.8.9.10.11.12.13.14.15.16.17.18.AKnow how to stop the unit and disengage the conti ols.Never place hands or feet between log and splitting w ed

IMPORTANTThis unit has been shipped without gasoiine or oii in the engine. After assembiy, refer to separate engine manuai for proper

ATTACHING TONGUE TO RESERVOIR TANK1.Beam Support/The tongue is shipped with the jack stand already attached to the tongue. The jack stan

ATTACHING THE ENGINE AND PUMP ASSEMBLY1. Using two Va" wrenches, remove the four hex bolts, lock washers and hex nuts which secure

FIGURE 10.FIGURE 11.ATTACHING THE HOSES Suction Hose1. The suction hose is attached to the reservoir tank, beneath the engine mounting pl

Ne.Start engine. Use the control handle to extend the wedge to the far extended position. Leave the wedge in this position (do not retra